2014 Suzuki Alto Fuse Box Diagram

2014 Suzuki Alto

Fuses and Relays

 

WARNING

To avoid harm to yourself or damage to your vehicle or battery, follow the jump starting instructions in the EMERGENCY SERVICE section of this manual if it is necessary to jump start your vehicle.

The level of the battery solution must be kept between the “MAX” and the “MIN” level lines at all times. If the level is found to be below the “MIN” level line, add distilled water to the “MAX” level line. You should periodically check the battery, battery terminals, and battery hold-down bracket for corrosion. Remove corrosion using a stiff brush and ammonia mixed with water, or baking soda mixed with water. After removing corrosion, rinse with clean water.
 

 If your vehicle is not going to be driven for a month or longer, disconnect the cable from the negative terminal of the battery to help prevent discharge.

 

Engine Compartment Fuse Box

Engine compartment - Fuse Location

Engine compartment - Fuse Panel Diagram

1. Main fuse
2. Primary fuse (IG)
3. Primary fuse (Not under ignition switch)
4. Empty
5. Empty
6. Headlight (R)
7. Headlight (L)
8. Empty
9. Radiator fan motor fuse
10. Fuel injection system fuse
11. Air conditioner (If equipped)

Engine compartment - Fuse Panel - Alto K10

1. Main fuse
2. Primary fuse (IG)
3. Primary fuse (Not under ignition switch)
4. Empty
5. Empty
6. Headlight (R)
7. Headlight (L)
8. Blower
9. Radiator fan motor fuse
10. Fuel injection system fuse
11. Air conditioner (If equipped)

This vehicle has three types of fuses, as described below : 

Main Fuse - The main fuse takes current directly from the battery.
Primary Fuses - These fuses are between the main fuse and individual fuses, and are for electrical load groups.
Individual Fuses - These fuses are in the fuse box and for individual electrical circuits.

MAIN FUSE / PRIMARY FUSES

80A All Electric Load
60A CIGAR, TURN/BACK, I.G./METER, (IG) HEATER, REAR DEFG, WIPER/ WASHER, POWER WINDOW
60A DOOR LOCK, TAIL, STOP, RADIO/ DOME, HORN/HAZARD

 

Main Fuse and Primary Fuses
The main fuse and primary fuses are located in the engine compartment. If the main fuse blows, no electrical component will function. If a primary fuse blows, no electrical component in the corresponding load group will function. When replacing the main fuse or a primary fuse, use service genuine replacement.

WARNING
If the main fuse or a primary fuse blows, be sure to have your vehicle inspected by an authorized SUZUKI dealer. Always use an authorized SUZUKI dealer genuine replacement. Never use a substitute such as a wire even for a temporary repair, or extensive electrical damage and a fire can result.

Fuse Box - Under the Dashboard 

 

 Fuse Panel - Under the Dashboard - Alto

1. HEATER 10A
2. WIPER/WASHER 15A
3. BLANK
4. STOP 10A
5. TAIL 10A
6. RADIO/DOME 15A
7. HORN HAZARD 15A
8. BLOWER 25A
9. IG 15A
10. TURN/BACK 10A
11. STEERING 30A
12. CIGAR 15A (Cigarette Lighter)
13. STARTER FUSE 30A
14. FUSE PULLER (Fuse Holder)

Alto K10

 Fuse Panel - Under the Dashboard - Alto K10

1. HEATER 10A
2. WIPER/WASHER 15A
3. DOOR LOCK 20A
4. STOP 10A
5. TAIL 10A
6. RADIO/DOME 15A
7. HORN HAZARD 15A
8. POWER STEERING 30A
9. IG 15A
10. TURN/BACK 10A
11. METER 10A
12. ACC 15A
13. CIGAR 15A
14. STARTER FUSE 30A
15. FUSE PULLER
16. POWER WINDOW 30A

Fuse Box Location

The fuse boxes are located in the engine compartment and under the driver’s side of the dashboard.  To remove the fuse box cover under the dashboard pull off the cover.

 NOTE:
To remove the fuse from the fuse box use the fuse puller given in the fuse box (under  dashboard) as shown in the illustration

Alto Fuse Box Location

NOTE:
Alto K10
Replace the fuse as described on the fuse box cover. Use the fuse puller given in the fuse box and keeping cover rib (1) in downward direction as shown.

Alto K10  Fuse Box Location